DesignJet T900 and T1500 Printer Series - Regulatory Information

5 Uwagi prawne
Numer rejestracyjny modelu
Do celów identyfikacyjnych ten produkt jest oznaczony numerem rejestracyjnym modelu. Numer
rejestracyjny modelu urządzenia to BCLAA-1202. Tego numeru prawnego nie należy mylić z nazwą handlową
(jak np. drukarka HP DesignJet) ani z numerem produktu (np. Z####X, gdzie Z i X są literami, a # oznacza
dowolną cyfrę).
Emisja hałasu przez produkt
Poziom ciśnienia akustycznego w pozycji obserwatora (LpA zgodnie z normą ISO 7779) wynosi poniżej 70 dB
(A).
USA: Electromagnetic compatibility (EMC)
The U.S. Federal Communications Commission (in 47 cfr15.105) has specified that the following notices be
brought to the attention of users of this product.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Shielded cables: Use of shielded data cables is required to comply with the Class B limits of Part 15 of the
FCC Rules.
OSTROŻNIE: Pursuant to Part 15.21 of the FCC Rules, any changes or modifications to this equipment not
expressly approved by the HP Company may cause harmful interference and void the FCC authorization to
operate this equipment.
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
●
Reorient the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●
Consult your dealer or an experienced radio/TV technician.
12 Rozdział 5 Uwagi prawne PLWW