DesignJet T900 and T1500 Printer Series - User guide
Change the front-panel display brightness
To change the brightness of the front-panel display, press , then , then Setup > Front panel
options > Display brightness, and select a value you want. Press OK to set the value. The default brightness
is set to 50.
Change the units of measurement
To change the units of measurement in the front-panel display, press , then , then Setup > Front
panel options > Unit selection, and select English or Metric. By default the units are set to metric.
Congure network settings
You can view and congure the network settings from the Embedded Web Server, the HP Utility or the front
panel.
To do so with the Embedded Web Server, select the Networking tab.
With the HP DesignJet Utility under Windows, select the Admin tab, then Network Settings. Under Mac OS X,
select Conguration > Network Settings.
The following settings are available.
●
IP Conguration method: Specify the way to set an IP address, selecting BOOTP, DHCP, Auto IP or
Manual.
●
Host name: Specify the IP name of the printer. The name may contain up to 32 ASCII characters.
●
IP address: Specify the IP address of the printer. Duplicate IP addresses on a TCP/IP network will cause
communication to fail.
TIP: Make sure that the combination of IP address, subnet mask and default gateway is valid. If these
three elds are inconsistent, you may not be able to connect to the printer at all until you x the problem
from the front panel.
TIP: If you change the current IP address and click Apply, the browser loses the current connection to
the printer because it is pointing to the old address. To reconnect, browse to the new IP address.
●
Subnet mask: Specify a subnet mask, which determines which bits specify the network and which bits
uniquely specify the node within the network.
●
Default gateway: Specify the IP address of a router or computer that is used to connect to other
networks or sub-networks. If none exist, use the IP address of the computer or the IP address of the
printer.
●
Domain name: Specify the name of the DNS domain in which the printer resides (for example,
support.hp.com).
NOTE: The domain name does not include the host name: it is not the fully qualied domain name,
such as printer1.support.hp.com.
●
Idle timeout: Specify the time that an idle connection is allowed to remain open when a remote
computer is waiting for the printer. The default value is 280 seconds. If set to zero, the timeout is
disabled and the connection is allowed to remain open indenitely.
ENWW Change the front-panel display brightness 39