DesignJet T900 and T1500 Printer Series - User guide

7. Put the blue stop onto the open end of the spindle, and push it towards the end of the roll.
8. Ensure that the blue stop is pushed in as far as it goes; until both ends are against the stops, then close
the latch.
If you are a regular user of dierent paper types, you can change rolls more quickly if you preload rolls of
dierent paper types on dierent spindles. Extra spindles are available for purchase, see Supplies and
accessories on page 131.
Load a roll into the printer
To start this procedure, you must have a roll loaded on the spindle. See Load a roll onto the spindle
on page 44.
TIP: If you have a T1500 series printer, do not try to open both roll covers at once; this may cause problems.
Always close one cover before opening the other.
NOTE: The rst two steps below are optional: you can start with step 3. However, in this case the printer will
not keep track of the length of the roll, and will print no barcode on the roll when it is next unloaded. So you
are recommended to follow all the steps, starting with step 1, unless you have turned o the Printing paper
info option. See Printing paper info on page 55.
1.
From the front panel, press , then if it is not already highlighted, then the roll icon, then
Load.
Alternatively, press , then , then Paper > Paper load > Load roll 1 or Load roll 2.
46 Chapter 6 Paper handling ENWW