DesignJet T900 and T1500 Printer Series - User guide
TIP: To cut roll paper while the automatic cutter is disabled, see Feed and cut the paper on page 57.
Feed and cut the paper
If you go to the front panel and press , then , then Paper > Form feed and cut, the printer
advances the paper and makes a straight cut across the front edge. There are several possible reasons why
you might want to do this.
●
To trim the leading edge of the paper if it is damaged or not straight. The cut strip falls into the basket.
●
To feed and cut the paper when the automatic cutter has been disabled.
●
To cancel the waiting time and print the available pages immediately, if the printer is waiting to nest
more pages (T930, T930 PS and T1500 series only).
NOTE: The printhead is serviced after each print, and the paper cannot be cut until the process completes,
so you may notice a delay.
NOTE: Photo and coated paper requires careful handling, see The print is scued or scratched on page 153.
TIP: To move the paper without cutting it, see Move the paper on page 55.
ENWW Feed and cut the paper 57