HP Designjet T2300 eMFP and T790/T1300 ePrinter Series - Web Connected Features User Guide

7 Control access to the product
Front-panel security settings
From the front panel, you can press , then , then Setup > Security, to control access to the
product in various ways.
●
USB drive: Enable or disable the use of a USB flash drive.
●
Firmware upgrade from USB: Enable or disable firmware updates from a USB flash drive.
●
Direct print using HP ePrint & Share: Enable or disable Direct Print using HP ePrint &
Share.
●
Enable Internet connection: Enable or disable the Internet connection.
●
Printer access control: Enable, disable or change the administrator password.
If an administrator password has been set, it must be given in order to perform the following
operations.
●
Change the security settings (including the administrator password itself)
●
Change the configuration of the Internet connection
●
Change the Automatic Firmware Update configuration
●
Enable or disable automatic downloading and/or installation of automatic firmware updates
●
Restore an earlier firmware version
●
External hard disk options
●
Reset factory defaults
NOTE: The administrator password can contain only characters that appear on the front panel's on-
screen keyboard. If you set a new password with the Embedded Web Server, it will reject characters
that do not appear in that limited character set.
16 Chapter 7 Control access to the product ENWW
Access control