HP DesignJet T790 and T1300 Printer Series - Using your printer
To turn it back on, use the power switch at the rear.
When the printer is powered back on, it takes about three minutes to initialize and check and prepare the
printheads. Preparing the printheads takes about 75 seconds. However, if the printer has been o for six weeks
or more, preparing the printheads could take up to 45 minutes.
The printer’s internal prints
The internal prints give various kinds of information about your printer. They can be requested from the front
panel.
Before requesting any internal print, check that the printer and the paper are ready for printing.
●
The loaded paper should be at least A3 landscape—420 mm (16.53in) wide—otherwise the print may be
clipped.
●
The front panel should be displaying the Ready message.
To print any internal print, press , then , then scroll down to Internal prints and press it, then select the
internal print you want. The following internal prints are available.
●
Demo prints: show some of the capabilities of the printer
—
Print drawing demo
—
Print rendering demo
—
Print GIS map
●
Conguration: shows all the current front-panel display settings
●
Usage report: shows estimates of the total number of prints, number of prints by paper type, number of
prints by print-quality option and total amount of ink used per color (the accuracy of these estimates is not
guaranteed) (T1300 series only)
●
HP-GL/2 palette: shows the color or grayscale denitions in the currently selected color palette
●
Service information: provides information needed by service engineers
●
PostScript font list: shows PostScript fonts available (PostScript printers only)
ENWW The printer’s internal prints 11