HP DesignJet T790 and T1300 Printer Series - Using your printer

●
Proxy > Primary port: Enter the proxy port number, zero by default.
●
Proxy > Restore factory settings: Return to the initial default settings.
If you have trouble with your Internet connection, see Cannot connect to the Internet on page 165.
Congure rmware updates
You can choose from the Embedded Web Server or from the front panel whether and how to download rmware
updates.
NOTE: If an administrator password has been set, it will be required to change these settings.
●
In the Embedded Web Server: select Setup > Firmware update.
●
Using the front panel: press , then , then Updates > Firmware update.
The following settings are available:
●
Check: If you select Automatically (the default setting), the printer will check automatically every week (or
after the printer has been restarted seven times, whichever happens rst) whether new rmware is
available. If you select Manually, the printer will not check automatically; you can check manually whenever
you like.
●
Download: If you select Automatically (the default setting), the printer will automatically download new
rmware whenever it becomes available. If you select Manually, you will be asked to approve each
download.
NOTE: Downloading the rmware does not mean that you have installed it in your printer. To install the
new rmware, you must conrm the installation manually.
●
Firmware update information: Information about the rmware currently installed
●
Firmware update history: A list of rmware versions that have been installed in the printer. It is usually
possible to reinstall the version immediately before the version that is currently installed, if you have some
problem with the current version.
Paper suitability options (T1300 series)
Paper mismatch action
If the paper currently loaded in the printer is not suitable for a particular job, the printer can either put the job on
hold until some suitable paper is loaded, or it can ignore the problem and print the job on the unsuitable paper.
There are several ways in which the loaded paper may be considered unsuitable:
●
The paper type is not as specied for the job
●
The paper source (roll 1, roll 2 or sheet) is not as specied for the job
●
The paper size is smaller than specied for the job
You can set the printer's behavior in such cases from the front panel.
●
Press , then , then Setup > Job management options > Paper mismatch action > Print anyway if
you want such jobs to print on whatever paper is loaded. This is the default option when printing from a
software application or from the Embedded Web Server; but it does not work when printing from a USB
ash drive, nor when copying.
●
Press , then , then Setup > Job management options > Paper mismatch action > Put job on hold
if you want such jobs to be put on hold. The printer will send an alert whenever a job is put on hold.
22 Chapter 3 Setting up the printer ENWW