HP DesignJet T790 and T1300 Printer Series - Using your printer

Prioritize a job in the queue
You can select a job in the queue and make it the next one to be printed. After selecting the job, press Move to
front.
If nesting is turned on (T1300 series only), the prioritized job may still be nested with others. If you really want
this job to be printed next, and not nested with others, rst turn nesting o and then move it to the front of the
queue as described above.
In the following cases, the Move to front button is not displayed:
●
The job is already at the front of the queue.
●
The job is on hold—in this case the Resume printing button is displayed instead.
●
The job has nished—in this case the Reprint button is displayed instead.
●
The job has some error condition.
Pause a job in the queue
If you select the job in the queue that is currently printing, you will see a Pause button, which you can press to
pause printing. The Pause button then changes to a Resume button, which you can press to resume printing.
Alternatively, you can press the Options button at the top right of the job queue screen, and then press Pause
printing.
Reprint a job from the queue
To reprint an already-printed job, select the job from the queue, then select Reprint.
When reprinting a print job, you cannot change the print settings, because the job has already been rasterized.
Delete a job from the queue
Under normal circumstances, there is no need to delete a job from the queue after printing it, as it will just fall o
the end of the queue as more les are sent. However, if you have sent a le in error, and want to avoid printing it,
you can simply select the job and then press Delete.
NOTE: If an administrator password has been set, it will be required.
In the same way, you can delete a job that has not been printed yet.
If the job is currently being printed (its status is printing), you can press Cancel and then Delete.
Delete all jobs
To delete all jobs in a queue, press the Options button at the top right of the job queue screen, and then press
Delete all jobs.
NOTE: If an administrator password has been set, it will be required.
Turn o the job queue
To turn o the job queue, press , then , then Setup > Job management options > Enable queue > O.
64 Chapter 9 Job queue management (T790 PS and T1300 series) ENWW