Maintenance & Service Guide HP Compaq Pro 4300 All-in-One Business PC

Stand bracket
The stand bracket is located near the middle of the computer, below the fan. Remove the bracket to
gain access to the drive cables and sidekey board cable assembly. The bracket is secured with four
Torx screws.
Figure 6-59 Stand bracket location
To remove the stand bracket:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer
on page 33).
2. Remove the center access panel (see
Hinge Cover Panel on page 34).
3. Remove the memory access panel (see
Memory Access Panel on page 36).
4. Remove the drive access panel (see
Drive Access Panel on page 38).
5. Remove the stand (see
Stand on page 61).
6. Remove the optical drive (see
Optical Drive on page 40).
7. Remove the top panel (see
Top Panel on page 58).
8. Remove the rear cover (see
Rear Cover on page 62).
Stand bracket 75