HP Compaq Business PC Maintenance and Service Guide Elite 8300 Series Convertible Minitower Elite 8300 Series Microtower Elite 8300 Series Small Form Factor Elite 8300 Series Ultra-Slim Desktop

5. Remove the Torx T15 screw that secures the assembly to the front of the chassis.
6. Rotate the right side of the assembly away from the chassis.
Figure 6-30 Removing the front I/O, USB, power switch assembly
7. Pull the assembly toward the right and away from the chassis while threading the wires through
the slot between the drive cage and chassis front and the hole in the front of the chassis.
To reinstall the assembly, reverse the removal procedure.
NOTE: When reinstalling the cables, route the blue cable through the top hard drive cage slot and
route the green and yellow through the bottom hard drive cage slot.
106 Chapter 6 Removal and Replacement Procedures Convertible Minitower (CMT) Chassis