Hardware Reference Guide HP Compaq Elite 8300 Touch All-in-One Business PC HP Compaq Elite 8300 All-in-One Business PC HP Compaq Pro 6300 All-in-One Business PC

Additional Information

For more information on removing and replacing hardware components, the Computer Setup utility,

and troubleshooting, refer to the Maintenance and Service Guide (available in English only) for your

computer model at

http://www.hp.com.

Installing the Rear Port Cover

1. Ensure that all cables are connected.

2. Place the cover against the computer (1), lining up the cable lock slot in the cover about 12 mm

(0.5 inch) below the cable lock slot in the computer. Slide the cover up and into position (2).

Figure 2-1 Installing the Rear Port Cover

Removing the Rear Port Cover

1. If a cable lock is installed on the rear of the unit, remove the lock.

Additional Information