Troubleshooting guide

Error messages 135
200 Series
201-Memory Error
Audible Beeps: None
Possible Cause: Memory failure detected.
Action: Run Insight Diagnostics ("HP Insight Diagnostics" on page 75) and replace failed components as
indicated.
203-Memory Address Error
Audible Beeps: None
Possible Cause: Memory failure detected.
Action: Run Insight Diagnostics ("HP Insight Diagnostics" on page 75) and replace failed components as
indicated.
207 - Invalid Memory Configuration Detected. DIMMs installed when no
corresponding processor is detected.
Description: Processor is required to be installed for memory to be used.
Action:
CAUTION: Before installing any processors, be sure to follow the guidelines provided in
"Performing processor procedures in the troubleshooting process (on page 16)." Failure to follow
the recommended guidelines can cause damage to the system board requiring replacement of the
system board.
Populate the processor socket or remove the DIMM.
207-Invalid Memory Configuration - DIMMs must be installed in pairs or sequentially
Audible beeps: 1 long, 1 short
Possible cause: The system is configured with only one FBDIMM and the system does not support single
FBDIMM mode, or multiple FBDIMMs are installed but were not installed in the proper order.
Action: Do one of the following:
• Install a valid FBDIMM pair if the system does not support single channel memory mode.
• Remove and install FBDIMMs in the proper order.
207-Invalid Memory Configuration - DIMMs Must be Installed Sequentially
Audible Beeps: 1 long, 1 short
Possible Cause: Installed DIMMs are not sequentially ordered.
Action: Reinstall DIMMs in proper order.