Troubleshooting guide

Error messages 161
1771-Primary Disk port Address conflict
Audible Beeps: None
Possible Cause: Internal and external hard drive controllers are both assigned to the primary address.
Action: Run the server setup utility and correct the configuration.
1772-Secondary Disk port Address conflict
Audible Beeps: None
Possible Cause: Address assignment conflict. Internal and external hard drive controllers are both assigned
to the secondary address.
Action: Run the server setup utility and correct the configuration.
1773-Primary Fixed Disk port Address conflict
Audible Beeps: None
Possible Cause: Fixed drive error detected.
Action: Run the server setup utility and correct the configuration.
1774-Slot X Drive Array - Obsolete data found in Array Accelerator...
...Data Found in Array Accelerator was Older Than Data Found on Drives. Obsolete Data has been Discarded
Audible Beeps: None
Possible Cause: Drives were used on another controller and reconnected to the original controller while data
was in the original controller cache. Data found in the array accelerator is older than data found on the
drives and has been automatically discarded.
Action: Check the file system to determine whether any data has been lost.
1775-Slot X Drive Array - Storage Enclosure Cabling Problem Detected: SAS Port Y:
OUT port of this box is attached to OUT port of previous box...
...Turn system and storage box power OFF and check cables. Drives in this box and connections beyond it will not be
available until the cables are attached correctly.
Audible Beeps: None
Action: For cabling configuration information, see the storage enclosure documentation.
1776-Slot X Drive Array - SCSI Bus Termination Error
...Internal and external drives cannot both be attached to the same SCSI port. SCSI port Y: Check cables
Audible Beeps: None
Possible Cause: External and internal connectors of the specified SCSI ports are connected to drives. The
indicated SCSI bus is disabled until this problem is resolved.
Action: The SCSI bus is not properly terminated when internal and external drives are connected concurrently
to the same SCSI bus.
1. Power down the server.