User guide

Using LO100 43

On ML150 G5 servers:

i. Press the down arrow (↓) key to scroll down to the Console Redirection option, and press the

Enter key.

ii. Verify the following settings:

— Console Redirection—Enabled

— Baud Rate—115.2K

— Terminal Type—VT100+

— Flow Control—None

— Redirection after BIOS POST—On

o On DL160 G5 servers:

i. Press the down arrow (↓) key to scroll down to the Remote Access Configuration option, and

press the Enter key.

ii. Verify the following settings:

— Remote Access—Enabled

— EMS support(SPCR)—Enabled

o On DL165 G5 and DL185 G5 servers:

i. Press the down arrow (↓) key to scroll down to the Remote Access Configuration option, and

then press the Enter key.

ii. Verify the following settings:

— Console Redirection—Enabled

— EMS Support (SPCR)—Enabled

— Serial Port Mode—09600 8,n,1

— Flow Control—None

— Redirection After BIOS POST—Always

— Terminal Type—VT100

— Sredir Memory Display Delay—No Delay

o On DL180 G5 servers:

i. Press the down arrow (↓) key to scroll down to the Remote Access Configuration option, and

press the Enter key.

ii. Verify the following settings:

— Remote Access—Enabled

— EMS support(SPCR)—Enabled

— Terminal Type—VT100

— Flow Control—None

— Redirection after BIOS POST—Always

o On SL165z G6 servers:

i. Press the down arrow (↓) key to scroll down to the Remote Access Configuration option, and

press the Enter key.

ii. Verify the following settings: