User guide

Using LO100 45
— Terminal Type—VT100
— Sredir Memory Display Delay—No Delay
I/O Device Configuration—Configure IO Port
— Serial Port 1 Address—3F8/IRQ4
o On HP ProLiant ML115 G5, ProLiant DL165 G5, and ProLiant DL185 G5 servers, verify the
following settings:
Configure Console Redirection
— Console Redirection—Enabled
— EMS Support (SPCR)—Enabled
— Flow Control—None
— Redirection After BIOS POST—Always
— Terminal Type—VT100
— Sredir Memory Display Delay—No Delay
I/O Device Configuration-Configure IO Port
— Serial Port 1 Address—3F8/IRQ4
o On HP ProLiant DL120 G5 servers, verify the following settings:
Console Redirection
— Console Redirection—Enabled
— EMS support—Enabled
— Baud Rate—115.2K
— Terminal Type—VT100
— Flow Control—None
— Continue C.R. after POST—Enabled
I/O Device Configuration
— Base I/O address—3F8
— Interrupt—IRQ 4
o On HP ProLiant ML150 G5 servers, verify the following settings:
Console Redirection
— BIOS Serial console—Enabled
— EMC Support (SPCR)—Enabled
— Baud Rate—115.2K
— Console Type—VT100
— Continue C.R. after POST—On
I/O Device Configuration
— Serial Port A—Enabled
— Base I/O address—3F8
— Interrupt—IRQ 4
o On HP ProLiant DL160 G5 servers, verify the following settings: