User guide

Using LO100 48

Press the down arrow (↓) key to scroll down to the Remote Access Configuration option, and

then press the Enter key.

ii. Verify the following settings:

— Remote Access—Enabled

— EMS support(SPCR)—Enabled

o On ML180 G5 servers:

i. Press the down arrow (↓) key to scroll down to the Remote Access Configuration option, and

then press the Enter key.

ii. Verify the following settings:

— Remote Access—Enabled

— EMS support(SPCR)—Enabled

— Terminal Type—VT100

— Flow Control—None

— Redirection after BIOS POST—Always

o On ML180 G5 servers:

i. Press the down arrow (↓) key to scroll down to the Remote Access Configuration option, and

then press the Enter key.

ii. Verify the following settings:

— Remote Access—Enabled

— EMS support(SPCR)—Enabled

— Serial Port Mode—9600 8,n,1

— Terminal Type—VT100

— Flow Control—None

— Redirection after BIOS POST—Always

4. Press the Esc key to return to the previous screen, or press the F10 key to save the changes and exit

setup.

After enabling Windows® EMS management, you can view the Windows® EMS management console

remotely from a client PC through an established telnet session to the IP address of the target server by

pressing the Esc+Q keys. You can end an EMS session by pressing the Esc+( keys. See your operating

system documentation for instructions on establishing telnet sessions.

NOTE: If you encounter problems logging in to the remote console, be aware that some telnet

programs might require you to enable their send line feed at end of line option. If

the remote console does not respond to the Enter key, try setting this option in your telnet

program.