Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

3. Install guide screws on the sides of the drive. The type of screws used depends on which drive
bay is being used to house the drive. If you are installing a 2.5-inch drive, you must install the
drive in an adapter bracket.
NOTE: Extra guide screws are installed on the hard drive bracket under the access panel.
Refer to
Installing Drives on page 92 for an illustration of the extra guide screw locations.
If you are replacing a drive, transfer the guides screws from the old drive to the new one.
●
If you are installing a 3.5-inch drive in either of the lower two bays (bays 5 and 6), install
four 6-32 silver and blue isolation mounting guide screws (two on each side of the drive).
Figure 6-22 Installing Isolation Mounting Guide Screws in a 3.5-inch Hard Drive
●
If you are installing a 2.5-inch hard drive into either of the lower two bays (bays 5 and 6), do
the following:
◦
Install four 6-32 silver and blue isolation mounting guide screws in the adapter bracket
(two on each side of the bracket).
Figure 6-23 Installing Isolation Mounting Guide Screws in the 2.5-inch Adapter
Bracket
96 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis