Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

●
If you are installing the drive in the upper bay (bay 4), install three standard 6-32 silver
guide screws (two on the right side and one on the left side in the screw hole closest to the
power and data connectors).
Figure 6-26 Installing Standard Guide Screws
4. Insert the hard drive into the bay as follows:
CAUTION: Make sure the guide screws line up with the guide slots in the drive cage. The use
of unnecessary force when installing any drive into the drive bay may result in damage to the
drive.
●
If you are installing a hard drive into one of the lower two bays (bays 5 and 6), slide the
hard drive into the drive bay until it locks. The drivelock automatically secures the drive in
the bay.
Figure 6-27 Installing a Hard Drive into the Lower Two Bays
98 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis