Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

To install the power supply, reverse the removal procedure.
System Board
Description Spare part number
System board, includes Trusted Platform Module (TPM) (includes replacement thermal material) 611835-001
System board, does not include Trusted Platform Module (includes replacement thermal material) 649742-001
1. Prepare the computer for disassembly (Preparation for Disassembly on page 73).
2. Remove the computer access panel (
Computer Access Panel on page 74).
3. When replacing the system board, make sure the following components are removed from the
defective system board and installed on the replacement system board:
●
Memory modules (see
Memory on page 79)
●
Expansion cards (
Expansion Card on page 83)
●
Fan sink (
Fan sink on page 112).
●
Processor (
Processor on page 114)
4. Remove the computer access panel (
Computer Access Panel on page 74).
5. Disconnect all cables connected to the system board, noting their location for reinstallation.
6. Remove the 10 screws (1) that secure the system board to the chassis.
7. Slide the system board toward the front of the computer so that the connectors loosen from the
rear of the chassis, and then lift the system board out of the computer (2).
Figure 6-49 Removing the system board
118 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis