Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

8. Route the cables through the slots beneath the drive cage, rotate the assembly into the chassis
(2), and then remove the assembly from the computer.
Figure 8-32 Removing the front I/O, power switch/LED assembly screw
To install the front I/O and power switch assembly, reverse the removal procedure.
NOTE: Be sure to correctly route the cables beneath the drive cage when reinstalling the assembly.
Proper cable routing prevents damage to the cables and allows the drive cage to close properly.
194 Chapter 8 Removal and Replacement Procedures – Small Form Factor (SFF) Chassis