Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

b. Press the tab on right side of the panel (1), and then swing the right side of the cage away
from the chassis to remove it (2).
Figure 9-30 Removing the I/O panel
12. Remove the three remaining screws (1) that secure the system board to the chassis.
13. Slide system board toward the front of the unit until the rear connectors are clear of their slots in
the chassis (2).
14. Lift the rear of the system board until it clears the chassis, and then remove the system board
from the chassis (3).
Figure 9-31 Removing the system board
To install the system board, reverse the removal procedure.
NOTE: When replacing the system board, you must also change the chassis serial number in the
BIOS.
System Board 235