Maintenance and Service Guide: 8200 Elite Series Convertible Minitower, 8200 Elite Series Microtower, 8200 Elite Series Convertible Small Form Factor, 8200 Elite Series Convertible Ultra-slim Desktop, 6200 Pro Series Microtower

Front Bezel Security
The front bezel can be locked in place by installing a security screw provided by HP. To install the
security screw:
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 73).
2. Remove the computer access panel (
Computer Access Panel on page 74).
3. Remove the front bezel (
Front Bezel on page 75).
4. Remove the security screw from the inside of the front bezel.
Figure 6-3 Retrieving the Front Bezel Security Screw
5. Replace the front bezel.
6. Install the screw through the interior of the front of the chassis into the front bezel. The screw
hole is located on the left edge of the chassis next to the top hard drive bay.
Figure 6-4 Installing the Front Bezel Security Screw
76 Chapter 6 Removal and Replacement Procedures – Convertible Minitower (CMT) Chassis