Reference Guide

*T8X39-90061*
*T8X39-90061*
T8X39-90061
© Copyright 2017 HP Development Company, L.P.
Printed in [English]
Printed in [French] EN FR ES
English
The information contained herein is subject to change without notice.
Need help? www.hp.com/support/amp100
HP AMP
1
Power : Press to turn the printer on or o. Press and hold to light up all the buttons.
When the power light is blinking, the printer is receiving and processing a job.
2
Cancel : When it lights up, press to stop current operation. When the printer is not active,
press to print a status report.
3
Wireless : Press to turn wireless capabilities on or o. If the light is blinking, the wireless
capability is on, but the printer is not yet connected to a wireless network. If the blue light stays
on, the printer is connected to a wireless network.
4
Control panel display: Indicates wireless status and signal strength , Wi-Fi Direct
status , paper-related warnings or other errors, and ink levels .
5
Information : Press to print the printer information page. If the button is amber and
blinking, press to get help for a warning or error.
6
Resume : When it lights up, press to resume printing.
7
Phone : Press to answer an incoming call, and then press again to end the call.
8,10
Volume : Press to increase or decrease volume.
9
Play/Pause : Press to play or pause the audio stream, and to mute or unmute a phone call.
11,12
Bluetooth : Press to turn Bluetooth on or o.
Press until the light ashes to enter Bluetooth paring mode. On your mobile device, select
HPAMP from a list of Bluetooth devices to pair.
Press and hold for eight seconds to reset Bluetooth.
Audio is stopped during printing to ensure the best print quality. It automatically resumes again
shortly after printing is completed.
To pair additional devices, make sure no other Bluetooth devices are connected to the speaker.
Eight paired Bluetooth devices can be stored in the printer memory. Two Bluetooth devices stored
in the printer memory can be connected at the same time.