HP ProDesk 400 G3 MT Business PC HP ProDesk 480 G3 MT Business PC HP ProDesk 490 G3 MT Business PC - Maintenance and Service Guide

Card reader
Description
Card reader, USB 3.0
Card reader, USB 2.0
The card reader is attached to the front of the chassis.
1. Prepare the computer for disassembly (Preparation for disassembly on page 23).
2. Remove the access panel (Access panel on page 24).
3. Remove the front bezel (Front bezel on page 25).
4. From the outside, front of the chassis, remove the Torx T15 screw that secures the card reader.
5. From the inside of the chassis, disconnect the card reader cable from the system board labeled SD RDR,
and then press the tab on the side of the card reader (1) and slide the card reader out the front of the
chassis (2).
To install the card reader, reverse the removal procedures.
Card reader 51