Specifications

4. Remove the battery (see Battery on page 34).
5. Remove the service door (see
Service door on page 35).
Remove the hard drive:
1. Using the cable tab (1), carefully lift up and disconnect the hard drive cable from the computer,
and then pull the cable out from the routing clips (2).
2. Remove the two Phillips M2.0×3.0 screws (1) that secure the hard drive to the computer.
NOTE: When removing the hard drive retention screws, make note of the location
and orientation of the hard drive retention brackets (2). The hard drive retention brackets are
included in the Hard Drive Hardware Kit, spare part number 676647-001.
Component replacement procedures 37