Specifications

3. Use the tab (3) to lift and remove the hard drive from the hard drive bay.
4. If it is necessary to disassemble the hard drive, perform the following steps:
a. Separate the front edges of the hard drive rubber bracket (1) from the hard drive
b. Remove the hard drive (2) from the bracket.
c. If necessary, disconnect the hard drive connector cable (3) from the hard drive. The hard
drive rubber bracket and hard drive connector cable are available in the Hard Drive
Hardware Kit, spare part number 676647-001.
To install a hard drive, reverse the removal procedure.
38 Chapter 4 Removal and replacement procedures