Specifications

Remove the WLAN module:
1. Loosen the Phillips M2.5×4.5 captive screw (1) that secures the wireless module compartment
cover to the computer.
2. Lift the right side of the wireless module compartment cover (2) until it rests at an angle.
3. Remove the wireless module compartment cover. The wireless module compartment cover is
available in the Plastics Kit, spare part number 676652-001.
4. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE: The #1 WLAN antenna cable is connected to the WLAN module “Main” terminal.
The #2 WLAN antenna cable is connected to the WLAN module “Aux” terminal.
5. Remove the two Phillips M2.0×3.5 screws (2) that secure the WLAN module to
the system board. (The WLAN module tilts up.)
44 Chapter 4 Removal and replacement procedures