Specifications

Remove the power connector cable:
1. Remove the Phillips M2.5×6.5 screw (1) and the two Phillips M2.0×5.0 screws (2) that secure
the power connector bracket to the base enclosure.
2. Remove the power connector bracket (3).
3. Release the power connector (4) from the clip built into the base enclosure.
4. Remove the power connector cable.
Reverse this procedure to install the power connector cable.
Speakers
Description Spare part number
Speakers (include subwoofer, speaker cable, and 4 rubber isolators) 676655-001
Before removing the speakers, follow these steps:
1. Shut down the computer.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 34), and then remove the following components:
a. Service door (see
Service door on page 35)
b. Hard drive (see
Hard drive on page 36)
c. Optical drive (see
Optical drive on page 39)
d. WLAN module (see
WLAN module on page 43)
66 Chapter 4 Removal and replacement procedures