Getting Started Guide

Getting Started
Solving Hardware Installation Problems
You may need to reconfigure the computer when you add or
remove hardware, such as an additional drive or expansion card.
If you install a plug and play device, Windows XP automatically
recognizes the device and configures the computer. If you install
a non–plug and play device, you must reconfigure the computer
after completing installation of the new hardware. In Windows
XP, use the Add Hardware Wizard and follow the instructions
that appear on the screen.
Solving Hardware Installation Problems
ice is not
i
ice is
l ly
l
ins in the
i
l ly
ins in the
i f
ice is i
ice wi
i f
t
confi
Problem Cause Solution
A new dev
Dev ce is not seated
Ensure that the dev
recognized as part
or connected
proper y and secure
of the system.
proper y.
connected and that p
connector are not bent down.
Cable(s) of new
external dev ce are
loose or power
cables are
unplugged.
Ensure that all cables are
proper y and secure
connected and that p
cable or connector are not bent
down.
Power sw tch o new Turn off the computer, turn on
external dev the external dev ce, then turn on
not turned on. the computer to integrate the
dev th the computer
system.
When the system
Reboot the computer and follow
adv sed you o
the instructions for accepting the
changes to he
changes.
guration, you
did not accept them.
www.hp.com Getting Started 20