Getting Started Guide

None
f
i
fl
i
vol
vol i
i
i
at a time until the 5
Getting Started
Diagnostic Front Panel LEDs and Audible Codes
Possible Recommended
Activity Beeps Cause Action
System does not
power on and
LEDs are not
System unable to
power on.
Press and hold the power
button or less than 4
seconds. If the hard dr ve
ashing.
LED turns green, then:
1. Check that the
voltage selector,
located on the rear of
the power supply, is
set to the appropr ate
tage. Proper
tage sett ng
depends on your
reg on.
2. Remove the
expans on cards one
V_aux light on the
system board turns
on.
3. Replace the system
board.
www.hp.com Getting Started 30