DYNAMIX HP-30 COAX 128 Mbps HPNA 3.
INTRODUCTION Dynamix HP-30 Coax, HCNA (HomePNA3.0 over Coax) to Ethernet bridge connects any Ethernet device to a high speed access device or to a LAN for Internet access. This bridge brings you the newest Ethernet compatible technology that uses the coaxial cable as the network’s physical wiring thereby eliminating the need to install new wiring. It is designed to operate on the coaxial TV cable installed in homes.
HARDWARE INSTALLATION Parts Names and Functions LED Indicators on the Front Panel
Ports on the Rear Panel Essential Hardwares
Hardware Connections 1. Select a convenient location for the bridge near the PC or Ethernet device to which it will be connected. The bridge should be kept away from excessive heat. 2. Using one coaxial cable to connect the HCNA port to F-Type connector on the wall. Using another coaxial cable to connect the other F-type TV port to TV set. 3. Connect the LAN1/LAN2 port to your Ethernet equipped device. 4. Connect the power adapter to the DC5V port into a wall outlet.
The figure above shows how to connect an xDSL modem to a home coaxial cable network. Follow the same steps to connect any Ethernet device such as a HUB or printer, to a coaxial cable network. Now you should have connected the LAN port, HCNA port and the DC5V port to the appropriate devices or lines.
SPECIFICATIONS Standards IEEE 802.3 10BaseT Ethernet compliant IEEE 802.3u 100BaseT Fast Ethernet compliant HomePNA 3.