Administrator's Guide

2. Align the replacement drive drawer rail with the three enclosure rails and then push the drive
drawer partially back into the messaging system enclosure so that approximately 2 inches of
the drawer is still out of the enclosure.
CAUTION: Do not push the drive drawer completely into the enclosure. You must first connect
the power coil assembly to prevent damaging the power coil assembly.
3. Pull the cable slightly out of the coil power plug and connect it to the midplane board.
4. Reattach the coil power plug bracket (1) and tighten the thumbscrew (2).
Removing and replacing the enclosure rails 135