Administrator's Guide

SET IPCONFIG
Syntax
SET IPCONFIG { DHCP | STATIC | LOCAL }
Description
Configures EM addressing mode to be DCHP, static, or link local. The setting takes effect
immediately. If mode chosen is static, other parameters are required (see below).
Restrictions
None
SET IPCONFIG STATIC
Syntax
SET IPCONFIG STATIC <ip address> <netmask> [<gateway>]
Description
Configures the IP settings for the EM to static mode. In selecting this mode, the IP address and
Netmaks are be set to <ip address> and <netmask>, respectively. These settings take effect
immediately. The Gateway address will be cleared if it is omitted. Note the Gateway address can
also be set by using the SET EM GATEWAY command.
Restrictions
None
SHOW NETWORK
Syntax
SHOW NETWORK
Description
Displays the network settings of the Enclosure Manager.
Restrictions
None
SHOW EBIPA
Syntax
SHOW EBIPA
Description
Displays EBIPA configuration information.
Restrictions
EM EBIPA control only functions for the 2 iLO processors in the server blades.
Server management
Use the commands in this section to perform server management operations.
CLI reference 171