Administrator's Guide

Description
Sets the persistent enclosure ID in the EMU. This ID is displayed on the 2 digit LED display on the
EMU module, displayed with SHOW ENCLOSURE INFO command and is provided to the
StorageWorks 1200m HBA in the MEZZ2 slot of the server through the MEZZPOS CLP string. The
command takes effect immediately.
IMPORTANT: Do not change enclosure ID. You will be unable to access the LUNs.
Restrictions
<id> is a decimal integer from 0 to 99.
SET ENCLOSURE NAME
Syntax
SET ENCLOSURE NAME "<enclosure name>"
Description
Sets the persistent enclosure name stored in the EMU. This name is displayed with SHOW
ENCLOSURE INFO command. The default (unset by user) value is ‘UnnamedEnclosure’.
Restrictions
<enclosure name> must be 1 to 32 characters long and includes all alphanumeric, underscore (_),
and dash (-) characters.
SET ENCLOSURE UID
Syntax
SET ENCLOSURE UID { ON | OFF | SLOW | FAST }
Description
Sets the blue enclosure UID. The enclosure has UID on both front and rear of the enclosure, however,
the front is only capable of being lit when enclosure power is on, while the rear UID is visible under
standby power alone. The Unit Identification LED on the enclosure to steady on, off, or one of two
blinking speeds. The system confirms the operation. There is no particular meaning to SLOW or
FAST.
Restrictions
Blinking rates are not user definable. SLOW is 1 Hz; FAST is 2 Hz.
Example
EM-78E7D1C12074> set enclosure UID ON
Enclosure's Unit Identification is ON
SET FACTORY
Syntax
SET FACTORY
Description
Restores configuration settings back to the factory defaults, including deleting any created user
accounts, except for the Administrator password, which remains unmodified. The EM restarts after
restoring the configuration settings. If the enclosure power is on, the iLOs are reset (to force a
refresh of the enclosure information passed to iLO) .
CLI reference 179