Administrator's Guide

• If the amber LED is not lit, proceed to the next step.
8. Open the ejector latches (1) on each side of the cache module slot.
Typically, opening the ejector latches ejects the cache module automatically. If the module
does not eject automatically after you open the ejector latches, remove the cache module (2)
by grasping only the edges.
9. Remove the cache module and the capacitor from the blade.
10. The Mezzanine NIC is underneath the controller card. Remove the controller card by loosening
the captive screws (1), and then remove the Mezzanine NIC (2).
Replacing the Mezzanine NIC
To replace the Mezzanine NIC:
1. Install the Mezzanine NIC , press down on the connector to seat the board (1), and then
tighten the captive screws (2).
2. Reinstall the controller card, and then Install the access panel.
3. Install the server blade in the enclosure.
94 Removing and replacing hardware components