Setup and Install

IMPORTANT: Prior to running the ECW, disable local User Access Control (UAC). If UAC is enabled
as a policy on the domain controller for the domain you will be joining, put the E5000 servers in an
organizational unit that has blocked the application of the domain policy. You can apply a different
group policy that will not apply any UAC policies on the E5000 server.
AcknowledgmentDescriptionStep
The Windows setup completes in
approximately 15 minutes, and the HP
E5000 Configuration Wizard starts.
Enter your locale information in the
Windows setup dialog and accept the
license terms.
The Administrator password is required
only the first time you run the wizard.
Press Next.
NOTE: Password complexity rules will
be enforced.
Enter and confirm the server
Administrator password.
NOTE: You will set the new
Administrator password on both servers.
Determine if there is an organization
convention that needs to be considered.
Complete each menu option in the
wizard to complete the minimum
required configuration.
If the wizard finds errors, it reports them
and stops. Exit the wizard, fix the
After you enter your EMU Administrator
password, the wizard displays the status
errors, and restart the wizard from the
Program Files menu on your system.
of tasks it must complete before
continuing.
Click Apply Settings to apply the
configuration settings or click Back to
modify them.
When the Summary screen appears,
review the summary report.
When you are ready to accept the
settings, click Finish to reboot the server.
If you do not want to reboot at this time,
clear the check box next to Reboot after
exiting the wizard.
IMPORTANT: The ECW joins the
server to your domain. Log in as the
domain administrator when it reboots
(not the local administrator).
The servers do not have to be on the
same IP subnet as the domain
After running the ECW, but before
running the EDT:
controllers. Networking must be
• Avoid simple errors by running some
networking tests (such as ping or
configured so that the E5000 servers
can communicate with the domain
controller.
tracert) to confirm that networking
and name resolution are configured
properly.
• Open Disk Management (in the
Server Manager, click Storage and
select Disk Management) to verify
that database volumes and the
recovery volume have been
formatted and mounted. If not, you
must do this manually or call HP
Support for assistance.
Review “Using the Exchange
Deployment Tool (EDT)” (page 9)
before you use the tool on Server 1.
Run the EDT on Server 1 to configure
Exchange 2010.
8 Running the E5000 Configuration Wizard (ECW)