User's Manual

user’s guide 45
8 troubleshooting
I don’t see the Welcome Screen when I
turn on my receiver for the first time
• Make sure your TV is displaying the appropriate
video source. You may need to use the Input,
Source, Select, or TV/Video button on your TV
or TV remote to change video sources. If you are
having trouble changing the video source, refer to
the instructions that came with your TV.
• If you did not connect the receiver directly to your
TV but are instead passing the signal through your
VCR, make sure your VCR is displaying the
appropriate video source. You may need to use the
Input or Source button on your VCR or VCR’s
remote control. Some VCRs only pass the signal
through when they are turned off. If you are having
trouble displaying the correct video source, refer to
the instructions that came with your VCR.
• Make sure cables are connected to the IN jack on
your TV or VCR, not the OUT jack.
• The cables you are using to connect your receiver
to your TV or other equipment may be damaged or
defective. Try exchanging the cables connected to
the receiver with other cables that you know are
working properly.
• Make sure you have firmly attached the power
adapter plug to the back of the receiver. Also,
verify the power adapter is plugged into a working
power outlet and that the outlet is not controlled by
a light switch.
My remote control isn’t working
• Make sure the batteries are inserted correctly.
• Try removing the batteries and reinserting them
without touching any buttons on the remote control.
• Replace the batteries with new ones.
Lexus.book Page 45 Monday, January 6, 2003 2:00 AM