Maintenance and Service Guide
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Preliminary replacement requirements
- Component replacement procedures
- Bottom cover
- Rear cover
- Hard drive
- Memory module
- Y-axis capacitor board
- RTC battery
- USB board
- X-axis capacitor board
- Converter board
- Media card reader board
- USB connector cable
- Speakers
- Display stand recess
- Power button board
- Battery
- Webcam/microphone module
- Audio/USB board
- WLAN module
- Air flow channel
- Display panel cable
- Fan
- System board
- Heat sink
- Display stand
- Wireless antenna
- Middle frame
- Power connector cable
- Using Setup Utility (BIOS) and HP PC Hardware Diagnostics (UEFI)
- Specifications
- Backing up, restoring, and recovering
- Power cord set requirements
- Recycling
- Index
5. Lift up on the top edge of the bottom cover (3), and then swing it up and forward until it detaches
from the computer.
6. Remove the bottom cover.
After the bottom cover is removed, the internal USB connector is accessible. If it is necessary to
remove or replace the wireless receiver dongle, follow these steps:
1. Disconnect the dongle (1) from the internal USB connector.
2. Remove the dongle (2) from the tablet.
3. Insert the replacement dongle (1) into the cavity next to the internal USB connector.
24 Chapter 4 Removal and replacement procedures