Maintenance and Service Guide

Display stand recess
Description Spare part number
Display stand recess 728058-001
Before removing the display stand recess, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
Bottom cover on page 23).
5. Remove the rear cover (see
Rear cover on page 26).
6. Disconnect the battery cable (see
Hard drive on page 27).
7. Remove the hard drive (see
Hard drive on page 27).
8. Remove the cover bracket (see
X-axis capacitor board on page 33).
Remove the display stand recess:
1. Remove the two Phillips PM3.0×4.5 screws (1) that secure the display stand cover to the middle
frame.
2. Remove the left (2) and right display stand covers (3).
The display stand covers are available using spare part number 728057-001.
Component replacement procedures 41