Maintenance and Service Guide
Table Of Contents
- Product description
- External component identification
- Illustrated parts catalog
- Removal and replacement procedures
- Preliminary replacement requirements
- Component replacement procedures
- Bottom cover
- Rear cover
- Hard drive
- Memory module
- Y-axis capacitor board
- RTC battery
- USB board
- X-axis capacitor board
- Converter board
- Media card reader board
- USB connector cable
- Speakers
- Display stand recess
- Power button board
- Battery
- Webcam/microphone module
- Audio/USB board
- WLAN module
- Air flow channel
- Display panel cable
- Fan
- System board
- Heat sink
- Display stand
- Wireless antenna
- Middle frame
- Power connector cable
- Using Setup Utility (BIOS) and HP PC Hardware Diagnostics (UEFI)
- Specifications
- Backing up, restoring, and recovering
- Power cord set requirements
- Recycling
- Index
3. Press down on the display stand release actuator (1). (The display stand (2) releases to the
open position.)
4. Disconnect the display panel cable (1) from the system board.
5. Release the display panel cable from the clips (2) built into the display stand recess.
6. Remove the eleven Phillips PM3.0×6.5 screws (3) that secure the display stand recess to the
middle frame.
7. Remove the display stand recess (4).
Reverse this procedure to install the display stand covers and display stand recess.
Power button board
Description Spare part number
Power button board (includes ribbon cable) 728063-001
42 Chapter 4 Removal and replacement procedures