HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Introduction
15HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
PTM required tools
The following tools are required to perform the PTM installation procedure:
■ 12-inch straight edge ruler
■ #2 Phillips screwdriver
■ 5/16-inch open end wrench
■ Torque wrench capable of 30-in/lb with #2 Phillips bit, 5/16-inch socket, and
4-inch minimum extension
■ Torque wrench capable of 70-in/lb with 7/16-inch socket and 2-inch minimum
extension
■ Torque wrench capable of 5-in/lb with 5/32-inch socket
■ 1/4-inch drive ratchet with 1/4-inch socket
■ 12-inch (30 cm) level