HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Installing a PTM
21HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
4. Remove the PTM access panels 1 on the left and right sides of the libraries
(see Figure 3).
Figure 3: Cosmetic anchor screw hole locations
5. On each library, remove the existing screws (2 Figure 3) and install four new
screws (P/N 0615079) in the two libraries to be connected. Do not tighten,
leave one-quarter inch clearance between the SEM washer and the trim
pieces.
6. Install the lower cabinet attachment channel on the left library (
1 Figure 4 on
page 23) using three bolts (P/N 0615113) and washers (P/N 0685521). Do not
fully tighten. Allow the lower cabinet attachment channel to float freely.
1 PTM access panel
2 Cosmetic anchor
screw holes
SHR-2104