HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Installing a PTM
29HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
To remove the bins (see Figure 8):
Figure 8: Removing the tape cartridge bin
1. Use a flat blade screwdriver to pry up the snap rivets securing the tape
cartridge bin to the library wall.
2. If the library is an ESL9198, lift up on the tape cartridge bin and remove it
from the library.
3. If the library is an ESL9322, remove the tape cartridge bin as follows:
a. Locate the latch at the bottom rear edge of the tape cartridge bin.
b. Using a flat blade screwdriver, press the latch forward (toward the front of
the tape cartridge bin).
c. While pressing the latch, lift up on the tape cartridge bin and remove it
from the library.
1 ESL9198 tape cartridge bin
2 Nylon snap rivet (1 per module)
3 ESL9322 tape cartridge bin
4 Snap rivet to be removed
5 Latch to press while lifting the tape
cartridge bin
1
3
4
5
2