HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Installing a PTM
37HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
Installing the PTM assembly
To install the PTM assembly:
1. Holding the PTM right side up, slide it through the right library pass through
cut-out and into the left library (see Figure 15 on page 38).
2. Slide the PTM mounting tabs onto the screws.
3. Install two 10-32 x 5/8 screws with #10 washers on the bottom mounting tabs
of the PTM, one in each library (see Figure 13).
Figure 13: PTM mounting points (ESL9198 shown)
Left and right ESL9198 libraries
PTM cable cover
Screws and washers
Push-in clips (3)
Bin shelf openings cover
and push-in clips
PTM mounting locations