HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Installing a PTM
38 HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
4. Connect the PTM cable to the PTM (see Figure 14).
Note: In Figure 14, the PTM is shown outside of the library for clarify.
Figure 14: PTM cable connection
5. Route the cable through the clips provided on the bottom of the PTM. Push
the excess cable through the cable hole in the bin wall.
6. Attach the pass through cable cover with four 10-32 x 5/8 screws and washers
to the bin wall to cover the cable and cable hole (see Figure 15). Tighten
screws to 30 +
3 in lb.
Figure 15: PTM installed
Cable
connector
Back side of PTM