HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)
Installing a PTM
41HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
Installing the PTM in an ESL9326 or ESL9595
The PTM installation consists of the following steps:
■ Removing the tape cartridge bins, page 41
■ Installing the PTM assembly, page 49
■ Installing the PTM cable cover, page 53
■ Centering the PTM assembly, page 54
■ Reinstalling the tape cartridge bins (ESL9326 only), page 56
Removing the tape cartridge bins
Before installing the PTM, certain tape cartridge bins must be removed from the
library. The specific tape cartridge bins to remove differ depending on the position
of the library in the multiple-unit configuration. Refer to Table 4 on page 31 for
information on which bins to remove.
Note: Right side of the library refers to the right side as you face the front of the library.
Left side of the library refers to the left side as you face the front of the library.