HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Installing a PTM
50 HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
3. Install two 10-32 x 5/8 screws with #10 washers in the locations shown in
Figure 13 on page 37 and Figure 22. Do not fully tighten; leave approximately
1/4 inch of space in between the washer and the bin wall.
Note: In ESL9326 libraries, the two lower mounting points are not available. Install
screws and washers in the upper two holes only, and mount the PTM on these screws
and washers.
Figure 22: Mounting points (ESL9326 shown)
Left and right library PTM mounting screws