HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Installing a PTM

60 HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide

3. On the left and right side of the front cosmetic assembly, install two 67.5 inch

(171 cm) pieces of foam gasket material as shown in Figure 31.

Figure 31: Installing the foam gasket

4. Adjust the width of the top of the assembly to be 1/16 of an inch less than the

top measurement found in step 1. This enables the cosmetic assembly to slide

in between the libraries for installation.

5. Tighten the nut closest to the top of the assembly to a torque value of 5 in/lb.

(.565 Nm)

6. Adjust the width of the bottom of the assembly to be 1/16 of an inch less than

the bottom measurement found in step 1.

7. Tighten the nut closest to the bottom of the assembly to a torque value of

5-in/lb. (.565 Nm)

8. Tighten the remaining nuts on the assembly to a torque value of 5-in/lb.

(.565 Nm)

9. Install the cosmetic panel assembly into the front gap between the libraries (

Figure 32 on page 61). Ensure sure that the open slots in the cosmetic angles

engage all four screws (

2 Figure 3 on page 21).

1 Foam gasket (right

side of assembly

shown uninstalled for

clarity)

SHR-187