HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Configuring and Calibrating a PTM
70 HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
9. Press the Escape key to get out of the Initialization function and then:
a. Select Flash Download and press the Enter key.
b. Select the firmware image that was supplied with the upgrade kit and
press the Enter key.
c. A warning screen appears prompting you to continue. Enter Y and press
the Enter key. The flash download operation takes from 45 to 60 minutes
to complete.
10. After the flash download completes, the control panel might display an ATL
model number if the memory module has been replaced. This is due to a
firmware issue whereby the HP model number is not retained. The HP model
number must be entered using the Tapelib diagnostic software.
Resetting the model number
To set the model to (6310080) HP ESL9000 Series, do the following:
1. Press the Standby button on the control panel to place the tape library in the
Offline state.
2. Reinitialize the NVRAM as follows:
a. Select Initialization
b. Select Init Non-vol Ram and press the Enter key.
c. An informational screen appears and prompts you to continue. Enter Y
and press the Enter key.
3. Press the Escape key, select Configure System, and press the Enter key.
a. Select the model number 6310XXX, enter 6310080, and press the Enter
key.
b. Select the number of bins and press the Enter key.
c. Select the number of drives and press the Enter key.
d. Select the SCSI ID (0) and press the Enter key.
4. Verify the new configuration by selecting Report System. Check that the
values displayed are what you entered. If it is ok, press the Escape key to exit
Tapelib.
5. Verify that the control panel is now displaying the HP StorageWorks
ESL9000 model number.