HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide (February 2005)

Configuring and Calibrating a PTM
79HP StorageWorks ESL9000 Series Pass-Through Mechanism (PTM) Installation Guide
Configuring a multi-unit library system using diagnostic
software
To configure libraries in a multi-unit system using diagnostic software:
1. Launch the diagnostic software on the PC.
2. From the Config Menu, select Multiple Unit.
3. From the Multi-Unit sub-menu, select Master Unit or Slave Unit for the
library configuration. The library connected to the host is the master library.
Any library in the multi-unit library system can be a master. The remaining
libraries are slaves.
Caution: When configuring multiple libraries in MUSL mode, there can be
only one master library.
4. After selecting Master Unit or Slave Unit, enter the Unit # (0-4) for the
library and # Units (1-5) for the number of libraries in the multi-unit library
system.
5. Repeat step 1 through step 4 for all the libraries in the multi-unit library
system.